Garage doors require continuous maintenance, but you don’t need to spend a fortune on repair services. Just be careful, and do some small fixtures every now and then. If it is too much for you to do on your own, you can contact a concord nc garage door company to help you out, there is plenty of help out there! Following, we are suggesting a few tips to help maintain your door.
- Install a Weather Seal
Weather seals save energy, it helps to prevent moisture from entering inside your garage door. These seals should be applied to the bottom end of the garage door between the door panels, and on the frame. You can use caulk to waterproof the door. If you are interested to know what caulk is, you could look at blogs from Seal With Ease to know more.
- Clean the Garage Door Track
Don’t spray any lubricant on door track whenever it becomes noisy or sticky. It doesn’t contribute to functioning door. Lubricates initiate collecting particles that harden or ruins how it should work. Garage door repair services recommend checking the track every week.
Therefore, instead of lubricating the track, they need to be cleaned properly. Just wipe the inside portion of track with damp cloth. Once cleaned, wipe the whole thing with dry cloth. Just remove the sticky residue on track.
- Realign Garage Door Sensors
When the garage door sensors don’t work properly, they may be knocked out of place. Align the sensors as realigning the sensors will need you to gently push sensors in the right place. The right position would be where both sensors face each other.
You can do it without calling an garage door opener installation service. When sensors are not aligned properly, their lights blink as indicators. Once the sensors are re-positioned and aligned properly, a solid light replaces blinking light.
- Reset the Opener
If your garage door closes and opens itself, no need to call professional Garage Door opener installation Glendale. Every garage door has its own instructions for reset, just shut off the power, and unplug opener. Wait for a few seconds and turn back the power and everything will be set.